BISCO® HT-1200 Series
BISCO® HT-1200 Series solid silicone rubber produced by Rogers Corporation is a range of materials from 40-70 Shore A durometer for general purpose applications where high temperature and fluid resistance is important. It is available in four grades and various common thicknesses
Insul-Fab carries HT-1200 Series in stock and fabricates the full line of Rogers Corporation BISCO® Silicone Products for your end use applications.
- Consistent performance in extreme service temperatures
- Resistance to UV light, ozone, and chemicals
- RoHS compliant
- Fabricates by die cutting and water jet
- May be laminated with adhesive for attachment
BISCO® HT-1200 Series Solid Silicone Rubber is firm and flexible, with resistance to high temperatures, tearing, and most fluids for general industrial and consumer type applications.
|BISCO® HT-1200 Series Solid Silicone Properties|
|Durometer, Shore A||40 ± 5||50 ± 5||60 ± 5||70 ± 5|
|Compression Set, max %||20-25|
|Service Temperature, Continuous Rec.||High: 425oF (218oC)
Low: -80oF (-62oC)
|Thickness Range, in (mm)||0.031-0.125
|Material Width, in||36|
|Format Availability||Fabricated Parts, Rolls, Sheets|
Insul-Fab is proud to be designated a Major Converter of Rogers BISCO® and we commonly have many of their products in stock for distribution and fabrication. Samples and part prototypes are readily available along with engineering support to choose the right material for your application.
Standard Product Availability
Within the most common BISCO product lines there are many thickness and color combinations available as standard, and more that are non-standard but available with minimum orders.
|BISCO® HT-1200 Series Solid Availability|
Contact us to find out if the BISCO SKU you are looking for is available in stock. Samples and non-tooled application prototypes available on request.
In addition to the Bisco HT-1200 series, INSUL-FAB also offers solid silicones from Diversified Silicone Products, part of Rogers Corporation and converts them for end-use applications.
Adhesive Backing and Lamination
Many applications for Rogers BISCO silicones require a pressure sensitive adhesive (PSA) with release liner on one or both sides for attachment in the end use. Some BISCO products are available from the factory with pre-applied adhesive (special part number for designation).
For more diverse adhesive selection and smaller lot sizes, Insul-Fab laminates silicone materials with PSA using a sophisticated in-house priming and lamination process to ensure a superior bond. While many products bond well to primed BISCO, we recommend the following laminating adhesives.
|3M 467MP and 3M 468MP||.002” and .005” unsupported acrylic (HP)|
|3M 9832 and 3M 9832HL||.005” double-coated acrylic (HP)|
|Concote CC593||.004” double-coated acrylic (GP)|
Unsupported acrylic adhesives offer an excellent bond and ability to conform to surface variations. Double-coated or supported acrylics provide dimensional stability to larger parts or thin cross sections, to prevent stretching during end use application.
- Environmental seals and gaskets
- Rubber tapes for long lengths and door seals
- Vibration isolation and energy absorption
- Gaskets for extreme temperatures
- Compression and rebound pads
- Thermal insulation
Brochures & Literature
Similar or related products
The Rogers logo and BISCO® logos are trademarks of Rogers Corporation or one of its subsidiaries. © 2019 Rogers Corporation. The technical data provided on this page is intended to assist you in material selection. It is not intended to and does not create any warranties, express or implied. The user should determine the suitability of the material for each application.